Chapter 4: Connecting The Wireless-G Broadband Router; Overview; Hardware Installation For Connection To Your Broadband Modem; Figure 4-1: Connecting Your Internet Connection - Cisco Systems LINKSYS WRT54G Guide De L'utilisateur

Wireless-G Broadband Router

Chapter 4: Connecting the Wireless-G Broadband Router

Overview

This chapter includes two sets of instructions. If the Wireless-G Broadband Router will be the only router in your
network, follow the instructions in "Hardware Installation for Connection to Your Broadband Modem." If you want
to install the Wireless-G Broadband Router behind another router in your network, then follow the instructions in
"Hardware Installation for Connection to Another Router."

Hardware Installation for Connection to Your Broadband Modem

1. Power down your network devices.
2. Locate an optimum location for the Router. The best place for the Router is usually at the center of your
wireless network, with line of sight to all of your mobile stations.
3. Fix the direction of the antennas. Try to place the Router in a position that will best cover your wireless
network. Normally, the higher you place the antenna, the better the performance will be.
4. Connect a standard Ethernet network cable to the Router's Internet port. Then, connect the other end of the
Ethernet cable to your cable or DSL broadband modem.

Figure 4-1: Connecting Your Internet Connection

Chapter 4: Connecting the Wireless-G Broadband Router
Overview
8