Battery Replacement; Replacement Procedure - Tripp-Lite SmartPro SMART750RMXL2U Manuel Du Propriétaire

Battery Replacement

Under normal conditions, the original batteries in your UPS will last many years. See Safety section
before replacing batteries. The batteries are designed for hot-swap replacement (i.e., leaving the
UPS in ON mode), but some qualified service personnel may wish to put the UPS in the OFF mode
and disconnect equipment before proceeding.
Note: Refer to the label on the battery retention plate for the R.B.C. part number.
SMART750RMXL2U and SMART1000RM2U Battery (RBC24VLCD)

Replacement Procedure

1 Remove Front Panel
4 x screws
1
Remove Battery Retention Plate
2
4 x screws
2
Disconnect Batteries
3
3
Remove/Recycle Batteries
4
4
18