Battery Replacement - Tripp-Lite SMART2500XLHG Manuel Du Propriétaire

Battery Replacement

Battery Replacement Door: Under normal conditions, the original battery in your UPS will last
several years. Battery replacement should be performed only by qualified service personnel.
Refer to "Battery Warnings" in the Safety section. Should your UPS require battery
replacement, visit Tripp Lite on the Web at http://www.tripplite.com/products/battery-finder/ to
locate the specific replacement battery for your UPS.
Carefully pull the
1
front panel away from
the UPS.
Place front panel on top of the unit.
Remove battery cover.
2
Use a screwdriver to remove the screws
holding the battery cover to the unit and
carefully remove the cover. Remove the
battery support bar. Disconnect the
wiring harness connecting the batteries
to the unit.
Remove old batteries.
3
Carefully pull the batteries from the
UPS.
Connect new batteries.
4
Connect the new batteries in exactly the
same manner as the old ones: positive
(red) connectors together and negative
(black) connectors together. Carefully
push batteries back into the UPS.
Reassemble UPS.
5
Reinstall the battery support bar, battery
cover and front panel.
UPS and Battery Recycling
Please recycle Tripp Lite Products. The batteries used in Tripp Lite products are
sealed Lead-Acid batteries. These batteries are highly recyclable. Please refer to
local codes for disposal requirements.
Call Tripp Lite for recycling info at 1.773.869.1234.
Go to the Tripp Lite Website for up-to-date information on recycling the batteries or
any Tripp Lite product.
Please follow this link: http://www.tripplite.com/support/recycling-program/
16-07-007-933607.indb 13
1
2
3
4-5
13
8/31/2016 10:04:09 AM