Quick Installation - Tripp-Lite SmartPro SMART750RMXL2U Manuel Du Propriétaire

Quick Installation

Plug the UPS into an outlet on
1
a dedicated circuit.
Note: After you plug the UPS into a live AC outlet,
the UPS (in "Standby" mode) will automatically
charge its batteries, but will not supply power to
its outlets until it is turned ON.
2 Plug your equipment into
the UPS.*
* Your UPS is designed to support only electronic
equipment. You will overload the UPS if the total
VA ratings for all the equipment you connect
exceeds the UPS's Output Capacity. To find your
equipment's VA ratings, look on its nameplates.
If the equipment is listed in amps, multiply the
number of amps by 120 to determine VA.
(Example: 1 amp × 120 = 120 VA) If you are
unsure if you have overloaded the UPS's
outlets, see LOAD icon description in LCD
Interface section under Basic Operation.
3 Turn the UPS ON.
Press and hold the
second. The alarm will beep once briefly.
Note: UPS system will function properly upon
initial startup, however, maximum runtime for the
unit's battery will only be accessible after it has
been charged for 24 hours.
button for one
A
6
1
2
A
3