Controllable Functions; Lubrication - LGB RhB Elektrolok Ge 4/4 II Mode D'emploi

Programming
• The characteristics can be changed repeatedly using the Configuration Variables
(CV).
• The CV numbers and the CV values are entered directly.
• The CVs can be read and programmed repeatedly. (Programming is done on the
programming track.)
• The CVs can be programmed in any order desired. (PoM - Programming can be
done on the main track). PoM is not possible with CVs CV 1, 17, 18, and 29. PoM
must be supported by your central controller (Please see the description for this
unit.).
• The default settings (factory settings) can be produced repeatedly.
• 14 or 28/126 speed levels can be set.
• All of the functions can be controlled according to the function mapping (see CV
description).
• See the CV description for the DCC protocol for additional information.
We recommend that in general programming should be done on the programming
track.
SERVICE

Lubrication

Oil each of the axle bearings now and then with a drop of Märklin oil (7149).
Changing Light Bulbs
Headlights: Carefully lift the glass from the lantern. Pull the light bulb out of the
socket with a pair of tweezers. Insert new light bulb. Put the model back together.
Interior Lighting: Pull the light bulb out of the socket with a pair of tweezers. Insert
new light bulb.
Changing Traction Tires
Remove the old traction tire with a small flat blade screwdriver: Lift the old traction
tire out of the groove in the driving wheel. Carefully push the new traction tire over
the wheel and insert it into the groove of the wheel. Check to make sure that the
traction tire is properly seated.

Controllable Functions

Lighting 1
Sound effect: whistle blast
Sound effect: Squealing brakes off
Raising/lowering pantographs, sequence
Sound: Greeting announcement
Sound: station announcements, sequence for Chur - St. Moritz
Sound effect: Operating sounds
Raising/lowering pantographs, direction-dependent
Sound on/off
ABV, off
Sound effect: Short whistle blast
Sound effect: Blower
Sound: vacuum pump
Sound effect: sanding
Sound effect: Announcement
Sound effect: Announcement
Sound effect: Announcement
Sound effect: Letting off air
Sound effect: Rail joints
Sound effect: Coupling together (buffer to buffer)
1
active in analog operation
2
with random sounds
3
is turned off by Function 7
10
3
1,2
1
LV + LR
1 Sound 1
2 BS
Sound
3
15+20
4 Sound 4+7
5 Sound 5
6 FS
7 Sound 21
8 Sound 8
9
10 Sound 2
11
12
13 Sound 9
14 Sound 11
15 Sound 15
16 Sound 16
17 Sound 17
18 Sound 6
19
20
21 Sound 14
22 Sound 18
23 Sound 19