Care And Maintenance; Disassembling The Secuquick Softline - AMC Secuquick softline Notice D'utilisation

EN
4.

Care and maintenance

Care for and maintain the Secuquick softline as follows:
ƒ Take apart and clean after each use.
ƒ Before using it again, check that it is working properly: Valves and seals, condition of the cover
closure.
ƒ Replace the sealing ring and other seals if they are damaged, brittle, shrunken or cracked.
These parts should be replaced at least every two years or after 400 cooking cycles.
Use only original spare parts for the relevant 4300 model.
Wear parts (sealing ring and gaskets) are available as spare parts from AMC. These can be replaced by the
user or by an AMC service center.
All other interventions may be carried out only by an AMC service center.
Table: Original sealing rings and seals:
Designation in user manual
Sealing ring 20 cm / 24 cm
Sealing washer for the operating pressure valve
Steam-venting valve
O-ring for safety valve 2
Sealing cap for safety valve 3
O-ring under the Visiotherm S
4.1.

Disassembling the Secuquick softline

Unscrew bell nut (6). Detach the bottom cover (7) from the top cover (8).
Remove the sealing ring (9) (tip: use a small spoon handle to help).
6
34
7
8
AMC item no.
10011155 / 10011156
10011151
10011187
10011134
10011149
10011185
9