Aligning The Setting Device, Right Side; 17 7.5 Aligning The Setting Device In Relation To The - Bosch ACC 100 Consignes D'utilisation

en 26 | ACC 100 | Testing / setting the ACC sensor
Fig. 19: Adjusting the slit diaphragm
3. Now, place the slit diaphragm on the ground next to
the front wheel (see Fig. 20).
4. Loosen the fixing screw on the KDS quick clamp and
align the wheel laser in such a way that the laser beam
passes through the center of the same diaphragm slit as
during the adjustment at the rear wheel. Use the fixing
screw to lock the wheel laser in place again.
Fig. 20: Aligning the wheel laser
5. Using the knurled screw, move the mirror vertically until
the laser beam is reflected onto the projection surface
of the wheel laser as close as possible to the outlet
aperture.
6. Read the value of the vertical position on the "V" scale
(see Fig. 21) and enter this value in the BMW diagnosis
system.
456176/2Rf
Fig. 21: Reading the vertical position value
7. Switch the wheel laser off again.
8. Unscrew the setscrew of the KDS quick-change clamp
and remove the wheel laser from the clamp holder
socket. After this, remove the KDS quick-change clamp
from the rear wheel.
9. Take the setting device off the rail. To do so, pull the
locking lever on the right-hand carry handle. This re-
leases the clamp, so that the setting device can easily
be removed from the rail.
|
1 689 979 811 2017-12-12
456177/3 Wn
456177/2 Wn
Bsp: V = 1,52
7.4

Aligning the setting device, right side

i
The setting device is aligned in relation to the right-
hand side of the vehicle in the same way as for the
left-hand side.
7.5 Aligning the setting device in relation
to the driving axis
1. Position and lock the setting device in place on the
rail so that it is situated centrally in front of the ACC
sensor (see Fig. 22). To do so, first pull the locking
lever on the right-hand carry handle to release the
clamp. Now place the setting device precisely on
the rail with the clamp open. Release the lever once
more to fix the setting device in place on the rail.
Fig. 22: Aligning the setting device in relation to the driving axis
2. Ensure that the setting device is mounted correctly on
the rail. In addition, ensure that the mirror is set to the
centre position of the tilting device (see Fig. 23, Pos. 1).
3
2
Fig. 23: Adjusting the mirror and spirit level
1 Centre position of tilting device
2 Knurled screw
3 Spirit
1
Robert Bosch GmbH