Safety Notes - Denstply Sirona SmartLite Focus Mode D'emploi

2

Safety notes

Be aware of the following general safety notes and the special safety notes in other
chapters of these Instructions for Use.
Safety alert symbol.
•
•
2.1 Warnings
Never modify SmartLite
promise safety and effectiveness.
2.1.1 SmartLite
®
• Always make sure SmartLite
Lite Focus
®
into correct position; see
• Always make sure light aperture is not covered by SmartLite
Figure D3
• Do not try to remove LED tip from handpiece as they are permanently connected.
• The LED tip is rotatable by 330°. Do not attempt to fully rotate the LED tip.
• Do not use the device as a tissue retractor, as this may damage the connection
between LED tip and handpiece.
• Do not use a damaged device, e.g. if among others the glass cover of the LED tip
is scratched, broken or missing.
• The SmartLite
spare shields included in the package or available as refill (see also [6.1 Acces-
sories]).
• Only authorized technicians should repair the handpiece or battery pack.
2.1.2 Charging base
• Low voltages are present inside the charging base (12 V DC). Do not open charg-
ing base when connected to power source. Use only under dry conditions. Do not
use if the charging base is wet. Avoid short circuit between contact pins inside the
charging base. Only authorized technicians should repair the charging base.
• Do not use for voltages different from the range indicated on the charging base.
• Note: Unplug power connector
er connector from the charging base.
• Always make sure the charging base is placed offside the dental unit and only
touched with clean/disinfected gloves to prevent from exposure to spatter or spray
of body fluids.
• Always make sure handpiece is completely reprocessed before inserting it into the
charging base.
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible
injury.
Focus
® ®
Focus handpiece
®
to avoid accidental aspiration (press SmartLite
®
Procedure D
and ).
Figure D4
Focus Shields will wear over time. Exchange defect shield against
® ®
3
or any of its equipment. Any modification may com-
1
Focus Shields
® ®
for details).
from power source before disconnecting pow-
4
are securely fixed to Smart-
6
Focus
®
Focus
®
Shield firmly
®
Shields (see
®
4