Step-By-Step Instructions - Denstply Sirona SmartLite Focus Mode D'emploi

3

Step-by-step instructions

3.1 Installation and charging (
1. Remove floor panel
(see
Figure B2
2. Connect jack
3. Close floor panel (see
4. Make sure power socket used for power connector is accessible at all times in
case of necessary emergency disconnection.
5. Insert battery pack
(see
Figure A2
SmartLite
®
6. To recharge the battery, insert the handpiece
(see
3 Figure B5
is recharging.
The SmartLite
utes operating time after 10 minutes recharging.
3.2 Operation
1. Protect LED tip from gross contamination by applying the single use SmartLite
Sleeves (see
2. Use the SmartLite
mounted SmartLite
Procedure D
to SmartLite
Shield firmly into correct position). Always make sure SmartLite
are properly mounted on SmartLite
(see
Figure D3
3. Adjust the LED tip: The LED tip is rotatable by 330°, thus the position of light
emission may be individually adjusted. The LED tip must be adjusted to an angle
that allows optimal curing of the restoration. The LED tip should be positioned as
closely as possible to the restoration.
4. Polymerization: Briefly press the ON/OFF key [1.1.1 ON/OFF key]. Audible op-
eration signals are described in [1.1.3 Audible signals].
5. To stop curing light before the end of the 20 second cycle, press ON/OFF key at
any time. To cure a restorative material that requires a curing time longer than
20 seconds, repeat activation by pressing the ON/OFF key after the end of each
20-second curing cycle (see also [2.2 Precautions]).
6. Curing times for a range of Dentsply Sirona materials are outlined in the Curing
Guide provided. When using other products, please refer to respective product's
Instructions for Use.
Procedure A
of charging base by lifting floor panel at its back end
3.1
).
to charging base socket
4.1
Figure B4
into SmartLite
2
and
Figure A3
Focus battery pack is pre-charged and ready to use upon purchase.
®
). The battery light will be flashing green, indicating battery
Focus Automatic Quick Charging Mode allows a minimum of 5 min-
® ®
).
Procedure C
Focus Shields supplied with the unit in combination with
® ®
Sleeves or use suitable, light filtering safety glasses (see
®
). Always make sure SmartLite
Focus to avoid accidental aspiration (press SmartLite
® ®
and
Figure D4
and
Procedure B
(see
3.2
) and plug in power connector
Focus handpiece
® ®
).
Focus
®
Focus without covering the light aperture
® ®
).
)
).
Figure B3
.
4
1
into the charging base
1
Shields are securely fixed
®
Focus
®
®
Focus
® ®
Shields
®
6