LGB 29300 Mode D'emploi page 36

Register Function values
CV5 Max. voltage
Voltage for highest speed step - if a lower top
speed is desired, decrease value.
CV5 after input of CV6
function value for CV to be programmed
CV6 CV to be programmed
CV29 NMRA configuration
Bit programming
Bit 1: direction, 0 = normal, 1 = reversed [0]
Bit 2: speed steps, 0 = 14 (LGB), 2 = 28 [0]
Bit 3: analog operation, 0 = not possible,
4 = possible [4]
Bit 4: not used [0]
Bit 5: speed steps, 0 = factory-programmed,
16 = user-programmed [0]
Bit 6: address area, 0 = 0-127 (LGB),
32 = 128-10039 [0]
To program, add the values for the individual
Bits and program the resulting function value.
Hint: To program a loco to reversed direction
of travel (for example, F7 A-B-A combination),
program function value 5.
Attention! Loco addresses 128-10039 and 28 speed
steps cannot be used with LGB MTS).
CV49 Voltage for function terminal F1
(depends on loco model, do not change,
as functions can be affected or destroyed)
CV50 Voltage for lighting terminals (see CV49)
CV51 Command for function terminal F1
0 = lighting button 9
1 = button 1 (buttons 2-8 not used)
9 = button 1 (buttons 2-8 used as well)
10 = button 2
11 = button 3
12 = button 4
13 = button 5
14 = button 6
Available Factory
pre-set
(1-255) [255]
[4]
(1-32) [32]
(1-32) [5]
[1]