emerio MC-122866.1 Mode D'emploi page 6

MC-122866.1
GENERAL DESCRIPTION
1. Speed button I (low speed)
2. Speed button II (high speed)
3. Motor unit
4. Bowl lid
5. Glass bowl
6. Non-slip mat
7. Blades
8. Whisk
9. Charger port and charger port
cover
10. Adaptor
11. Battery indicators
12. Storage cover
BEFORE FIRST USE
1. Before using the product for the first time, please ensure that the battery is fully charged and the parts that
come into contact with the food shall be cleaned thoroughly.
2. This appliance is equipped with a protection switch and it can be only operated by pressing and holding the
speed button for 1 second later.
3. Clean the appliance as described in section "cleaning and maintenance". Take care when handling sharp
blades.
NOTE: This set working time of the appliance for one cycle is around 65 seconds. After that, the appliance will
stop working automatically.
BATTERY CHARGING
1. The appliance must be charged by the adaptor provided with the appliance.
2. Plug one end of the adaptor into the charging port and the other end into the power outlet.
3. When charging, the indicators illuminate alternately from bottom to top. When fully charged, the battery
indicators will stay lit.
4. The appliance cannot be activated for working when it is being charged.
NOTE: After fully charged, the appliance can keep working for 5 cycles continuously, and minimum 3-minute
rest time must be maintained between two consecutive cycles.
HOW TO CHOP FOOD
1. Make sure the non-slip mat is in place. Place the appliance on the table.
2. Place the blades onto the spindle of the bowl and pour in the food to be chopped. Take care the blades are
very sharp.
NOTE: This appliance is equipped with two sets of blades.
Attach the two sets of blades together; rotate to fix firmly
by the groove on the shaft of blade 2 and square convex
point on the blade 1. Do not over tighten.
3. Place the lid on to the bowl. Place the motor unit onto the
lid. Make sure it fits properly.
- 5 -
EN