John Bean B 1200P Manuel D'utilisation page 108

6
3
8
7
108
4
4-10
5-56
5-57
5-58
Operation
5.13.3 Start optimisation/weight
minimisation
Procedure:
— Clamp the wheel or bare rim.
— Enter correct rim dimensions, or check existing
inputs for correctness.
— Close the wheel guard (if necessary press the
START key).
— Starting from the BALANCING menu press key 6
Optimisation – Minimisation (Fig. 4-10).
The OPTIMISATION MENU "1" screen (Fig. 5-56) is
displayed.
If an optimisation/weight minimisation result has
already been saved, press the 7 key (Fig. 5-57); The
program then continues from the step where it was
interrupted, with the relative measurement values and
the balancing optimisation / weight minimisation may
continue.
At this point, you can choose whether to continue with
Optimisation (Key 8), or go to Minimisation (Key 4).
5.13.3.1 OPTIMISATION
— Clamp the rim only.
— Perform a measuring run.
— In the BALANCING menu press key 3 (Fig. 4-10).
The OPTIMSATION "1" screen page appears (Fig.
5-56).
— Press the key 8 (Fig. 5-56).
The OPTIMSATION "2" screen (Fig. 5-58) is displayed.