Advanced Spoke Detection - John Bean B 1200P Manuel D'utilisation

72
1
5-34
5-35
5-36
Operation "PROFILING"
At every ALU change the balancer automatically
recalculates the value and position of the weights.
The wheel measuring run may have detected the
number of spokes: in this case the hidden weight mode
can be entered with "SPOKE" (1, Fig. 5-34).
- With PROFILING MEASURING RUN
ACTIVATED,
the machine proceeds directly to the measuring run.
At the end of the run, the unbalance values and the
points where the balancing weights should be applied
are displayed.
Only if it is impossible to read the wheel width (e.g.: rim
without a tyre) the wheel data input screen page appears
automatically, with the values not detected shown in red.
5.5.2

Advanced Spoke Detection

This mode, which can be activated when required,
allows absolute precision when detecting the position
and dimensions of the rim spokes, to allow more
precise behind the spokes placement. By the laser
scanners can't recognise the spokes or the operator
decides he is dealing with a rim with a particularly
complex shape, enable the Advanced Spoke Detection
function which recognises any type of spokes, even
those with unusual shapes, for example: paired,
oblique, with holes or of different sizes to one another
(fi g. 5-35).
Before performing the measuring run:
•
From the FUNCTIONS screen select "Spoke
Detection" then "ADVANCED".
•
Perform the normal procedures for the run.
Note: This function increases the time for the total
measuring cycle by 5 seconds
When the Spokes Advanced Gauge is active, the
screen shown in the fi g. (Fig. 5-36) is displayed.