Rittal 7979.711 Notice D'installation Et D'utilisation page 26

Settings of the RCM

Once again, keep pressing the "Up" key or the "Down" key until
the required digit is displayed in the second position of the PIN.
EN

Move to the third and fourth positions of the PIN and set them
in the same way.
Note:
"1221" is the preset PIN for accessing the Configuration menu. This PIN can be modi-
fied via the RCM website.


Finally, press the "Enter" key. The DHCP menu will appear.

The " " symbol marks the current DHCP setting.

Use the "Down" key to select the DHCP setting "OFF" and
press the "Enter" key to confirm your selection. The first page
of the IP v4 Setup menu for setting the IP address will appear.

In the same way as you entered the PIN, enter an IPv4 address
permitted in the network and confirm with "Enter".

Press the "Down" key to move to the page 2 of the IP v4 Set-
up menu.

If necessary, amend the subnet mask to the required setting
and confirm with "Enter".
26
Make a note of the new PIN number and keep it somewhere safe.
Rittal RCM Inline Meter