Assembly Notes; Operating And Display Elements - Rittal 7979.711 Notice D'installation Et D'utilisation

Product description, Assembly notes, Installation and operation of the RCM
3.3 Operating conditions
The RCM Inline Meter may be operated only under the operating conditions listed in section 9 "Tech-
nical specifications".
3.4 Base configuration
As standard, the RCM is activated to automatically obtain an IPv4 address from a DHCP server in the
network. If no DHCP server is available, the following base configuration is preset:
IP address:
Netmask:
Gateway:
Security PIN:
Speeds
Ethernet 1 and 2 (RJ 45):
If the RCM cannot be included in the network with these settings, they can be changed via the display
or the RCM website (see Section 6).
4

Assembly notes

The RCM Inline Meter is designed for installation within the 482.6 mm (19") level. The assembly com-
ponents required for straightforward installation are included with the supply.
5 Installation and operation of the RCM
5.1

Operating and display elements

The operating and display elements are shown in fig. 5. The display direction and the assignment of the
four keys at the side of the display will align correctly regardless of the RCM's orientation. The actual
assignment of the keys is shown correctly on the display.
Key to fig. 5
1 "Enter" key
2 "Esc" key
3 Display
4 "Down", "Next" key and "–" key when entering the pin.
5 "Up", and "+" key when entering the pin.
6 Reset button to restart the RCM
7 Green LED to indicate the power supply
8 Multi-LED for status display
9 Ethernet interface 1 RJ 45
10 Ethernet interface 2 RJ 45
11 RS232 serial interface
12 CAN bus connection (daisy chain) for CMC III sensors, 24 V
13 Digital input
14 Alarm relay output, max. 48 V DC / 2 A
15 USB connection for firmware updates and for data logging
Rittal RCM Inline Meter
192.168.0.200
255.255.255.0
0.0.0.0
1221
10 / 100 / 1000 Mbit/s
,1 A
EN
23