Master Slave Mode - Ibiza Light LAS50GG Manuel D'utilisation

This appliance has 9 DMX512 tunnels：
Channel DMX512 code Control content
0~63 Auto running
64~127 See all single photos via DMX
Channel 1
128~191 Sound control
192~255 Black out
Channel 2 0~255 Select 84 gobos
2~131 X axis rotation by hand-made via DMX
Channel 3
132~255 X axis rotation automatically
2~131 Y axis rotation by hand-made via DMX
Channel 4
132~255 Y axis rotation automatically
2~131 Move right and left by hand-made via DMX
132~162 Move towards left automatically
Channel 5
163~194 Move towards right automatically
195~255 Move left and right automatically
2~131 Move up and down by hand-made via DMX
132~162 Move down automatically
Channel 6
163~194 Move up automatically
195~255 Move up and down automatically
2~83 Zoom in /out by hand-made via DMX
Channel 7 84~163 Zoom out automatically
164~255 Zoom in automatically
2~108 Rotation by hand-made via DMX
Channel 8
109~255 Rotation automatically via DMX
SPECIFICATIONS
1. Laser type: Using full solid semiconductor laser. Green laser wave length
532nm.
2. Power supply: 230V, 50Hz
3. Laser power: 532nm50mW
4. Channel: 9 channels
5. Control mode: sound activated, auto running, DMX (8 channels) and
master/slave
6. Mode: Auto motion picture, single picture, beam controlled by sound,
lighting shelter.
7. Features and effect: , high speed optical scanner to generate built-in or
customizable 3D animation graphics in single green color, , can control
speed and size of pattern, display all kinds of patterns
International Laser Display Association such as flower pictures,
lauch-four-sides, puzzled web, time and space tunnel etc.
8. Applicable for Disco, pub, bar, KTV room, club, large stage,
entertainment centre, special events, etc.

MASTER SLAVE MODE

This unit can be run in Master Slave Mode. In Master Slave Mode one unit
will be the master and all units set to Slave Mode will follow the Master
patterns and movements.
MASTER SLAVE SETTINGS
To select Master Slave Mode you need to set up the DMX dip switches.
1. Set Dip Switch 10 to the on position on Master and Slave unit
2. Set Dip Switch 1 to the on position for Master Unit
3. Set Dip Switch 1 to the off position for Slave Unit(s)
4. Set Dip Switch 2 to the on position for auto running
5. Set Dip Switch 2 to the off position for sound activate
6. Connect XLR Cable to output of Master Unit and then to the input of the
slave unit.
7. Set Sensitivity/Volume knob to the desired level (centre position
recommended)
When changing modes using the dip switches, the unit must always be
turned off so that it can reset itself. You connect up to 8 Slave units to one
Master. More units may be connected but it will depend on the distance
apart and may cause the units not to function accurately.
DMX512 operation instructions
This laser light is controlled by the standard DMX. Please connect
controlling panel with the lighting as following fig:
Before using the DMX512 controller, you should set the channel address. It
can be set 001-511 address, every binary address switch has a digital no,
please refer to ：
No.
1st
2nd
3rd
4th
5th
When setting, the number of the selector dial switch must be equal to the
sum of digital numbers. Please refer to :
specified by
Digital No. No.
1 6th
2 7th
4 8th
8 9th
16 10th
Digital No.
32
64
128
256
Function switch
2