Auto Mode - Ibiza Light LP-36 LED Manuel D'utilisation

General instructions
Before plugging this unit to power make sure the voltage in your area matches
the required voltage for the LED PAR-64 Pro. All PAR-LED PRO units can be
powered by 90/260V and 50/60Hz.
There are 2 ways to control your PROFESSIONAL LED PAR-64. The first
option is by 'stand alone' function, and probably the most used option by an
external controller via DMX. The order in which fixtures are connected in a
DMX line does not influence the DMX addressing, the controller always will
recognize the fixture by its address.
XLR Wiring

AUTO Mode

All DIP switches below are set to auto mode (without DMX controller)
© Copyright Lotronic 2011
XLR Pin Configuration
Pin 1 = Ground
Pin 2 = Data Compliment (negative)
Pin 3 = Data True (positive
DMX values and Functions when a controller is connected:
CHANNEL VALUE FUNCTION
1 0 No function
1 – 127 Strobe slow to fast
128 No function
129 – 255 RGB dimmer 0-100%
2 0 No function
1 – 255 Red 0-100%
3 0 No function
1 – 255 Green 0% - 100%
4 0 No function
1– 255 Blue 0% - 100%
DMX Address and Function (see auto mode)
DIP8 &/or 9 to
ON
DIP10 to OFF DIP7 to ON
DIP6 to ON
DIP5 to ON
DIP to ON DMX512 & Master Modes
DIP1-9 : Setting of DMX address
Specifications
 Operating modes: DMX512, Master/Slave, Auto, Sound activated
 Functions: Color changer (fast or slow), strobe & dimmer
 Lamp: 60 x 10mm hi bright LEDs
 Life time of the lamps:80-100.000 operating hours
 Colors:16.7 millions
 Consumption:10W
 Dimensions: 150 x 150 x 210mm
 Power supply: 90V-250Vac/50-60Hz
IMPORTANT NOTE: Electric products must not be put into household
waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed
Audio Mode DIP1-4 Color
Slow DIP1-4 Speed
Fast DIP1-4 Speed
Strobe DIP1-4 Speed
.
3