Ibiza Light LAS50GG Manuel D'utilisation

L A S E R
L A S E R
LAS50GG (15-1034)
GB - INSTRUCTION MANUAL
Please read this instruction manual before use
Please check when open the package
In order to use this product safety and correctly, please read this manual
carefully before using and follow this manual strictly to operate it. When
received this product, please take it carefully and check whether it has any
problem caused by transportation.
And also check the parts as follows:
 Laser light: 1 PCS
 DMX512 signal cable : 1 PCS
 Power cable: 1 PCS
 Instruction manual: 1 PCS
INSTALLATION
1. Please make sure the voltage you are using complies with the
o
marking on the product before installation.
2. It must be installed by a specialist, fixed safely and adjusted to
o
suitable irradiation angle.
3. Please make sure there isn't any flammable and volatile object such
o
as ornament etc. at the range of 0.5M when installing. The distance
between lighting and wall must be at least 15CM
4. Please make sure there isn't anything to stuff the ventilation funs and
o
exhaust pipe.
5. Based on safety reason, please use the safe rope to wind the lighting
o
at the weight of 10 times.
6. This products should be installed fixedly
o
7. Based on safety reason, wire to grounding is very important.
o
NOTICE
 Please follow this manual to operate strictly. Don't open it yourself. This
product should be repaired by specialist if have any problem.
 Please keep this product in dry air. Don't use it under rainy or wet or
dusty conditions.
L I G H T
L I G H T
 Fixed installation: Prevent this product from strong vibration or impact.
Don't use it under shaking conditions.
 Prevent the other things to enter into the products to cause some
problem.
 Please make sure the exhaust channel is no problem
 during working
 Please take notice that the plug is connected to the socket fixedly
before turn on the power.
 Don't turn on or off this lighting frequently because it will shorten laser
using age. Try not to keep it work for so long time.
 Based on semiconductor laser speciality, it needs to turn off for 15
minutes after using two hours. And then reuse until it become cooling.
 Don't use any telescope to observe laser because it will become
dangerous.
 Don't touch the products and pull the power cable powerfully with wet
hands.
 The distance between lighting and objects is at least 1M.
 There aren't any parts for user to repair in this product. Don't open it.
 When the brightness of semiconductor laser becomes darker or other
destroy, please contact the dealer immediately.
 Please notice anti-quake when re-transportation. It is better to use
original packing.
WARNING
Please make sure the power has been cut off when do any installation and
repair.
This lighting laser danger rating is Class III B. It is dangerous to observe in
the beam of light directly. The minimum irradiated distance is 13CM and the
longest irradiated time is below 10 seconds.
Please make sure the distance between lighting and flammable things is at
least 0.5M.
MAINTENANCE
Please maintain the products regularly. Using cotton stick dipped into
alcohol to clean the glass to optimize light output. Don't use wet clothes or
other chemical solvent to clean glass. The cleaning frequency should be
based on the operation frequency and environmental circumstances. We
suggest cleaning it every 20 days.
Please use clean towel to scrape the face of metal case, check and clean
the exhaust channel regularly.
Mention: When the tenth dial switch is off the laser lighting will be defaulted
into auto-motion play pattern. When the tenth dial switch is on, the laser
lighting will be defaulted into beam patterns controlled by sound.
Note: When the lighting was connected one by one, do remember: connect
a 120ohm resistance in series between PIN1 and PIN2.
Switch the power on. The controller will start to work.
1