Doors - Maytag MFT2772HEZ Guide D'utilisation Et D'entretien

PROBLEM
Water from the dispenser is
warm

Doors

To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search
for "door closing and door alignment."
PROBLEM
The doors will not close
completely
The doors are difficult to
open
The doors appear to be
uneven
The refrigerator is unsteady
or it rolls forward when
opening and closing doors
36
POSSIBLE CAUSES
Water from the dispenser is chilled
to 50°F (10°C).
The refrigerator has just been
installed.
A large amount of water was
recently dispensed.
Water has not been recently
dispensed.
The refrigerator is not connected to
a cold water pipe.
WARNING
Explosion Hazard
Use non ammable cleaner.
Failure to do so can result in death, explosion, or re.
POSSIBLE CAUSES
The door is blocked open.
A bin or shelf is in the way.
Recently installed
The door gaskets are dirty or
sticky.
The doors need to be aligned,
or the refrigerator needs to be
leveled.
The refrigerator brake feet are not
snug against the floor
SOLUTIONS
This is normal.
Allow 24 hours after installation for the water supply to cool
completely.
Allow 3 hours for the water supply to cool completely.
The first glass of water may not be cool. Discard the first glass of
water dispensed.
Make sure the refrigerator is connected to a cold water pipe. See
"Water Supply Requirements."
SOLUTIONS
Move food packages away from door.
Push bin or shelf back into the correct position.
Remove all packaging materials.
Clean gaskets and contact surfaces with mild soap and warm
water. Rinse and dry with soft cloth.
See "Refrigerator Leveling, Door Closing and Alignment."
Remove the base grille. Turn both brake feet (one on each side)
clockwise, the same amount, until they are snug against the floor.
See "Refrigerator Leveling, Door Closing and Alignment."