HP LASERJET 2200 Serie Guide De Mise En Marche Rapide page 19

Note Before installation is complete, make sure that there is a check mark next to "Print a
test page" (when the prompt appears).
In Windows 2000, if the "Found New Hardware Wizard" window reappears before
installation is complete, click Cancel.
4
5
6
If You Connected a USB Cable
Note Windows 3.1x, 95, and NT 4.0 do not support USB cable connections. The following
instructions are for computers running Windows 98, 2000, or Millennium. If you want to
connect a USB cable to your Macintosh, see "Macintosh Installation" on page 17.
1
2
Windows 98
ENWW
Click Finish.
If you are prompted to restart your computer, click Yes. The test page should print
after your computer restarts. If you are not prompted to restart your computer, a
test page should print immediately. (If you have Windows NT 4.0 you do not need
to restart your computer.)
If the test page printed correctly, installation is complete. Continue to "Step 8:
Record and Store Important Information" on page 20. (If nothing prints or if the
test page does not print correctly, see "If You Have Problems" on page 21.)
If your computer is off, turn it on now. Quit any open programs.
Follow the steps for your Windows version:
a The "Add New Hardware Wizard" window should appear on the
computer display. Click Next>.
b Select "Search for the best driver for your device. (Recommended)"
and then click Next>.
c Click the boxes as needed so that there is a check mark next to
"Specify a location:" (and NO check marks next to "Floppy disk drives"
and "CD-ROM drive").
d Place the HP LaserJet 2200 CD in the CD-ROM drive.
e Under "Specify a location:", type D:\98ME_USB (where D is the letter of
your CD-ROM drive). Click Next>.
Step 7: Install Printer Software 15