Troubleshooting Guide - Pattfield Ergo Tools PE-EBH 7530 Mode D'emploi

11. Troubleshooting guide

Fault
Motor does
not start
Motor perfor-
mance drops
Notice! For protection, the motor is equipped with a thermal
switch which cuts out when the motor is overloaded and swit-
ches on again automatically after a short cooling period.
Anl_PE_EBH_7530_SPK7.indb 223 Anl_PE_EBH_7530_SPK7.indb 223
Possible causes
- No power at the plug
- Cable defective
- Switch/plug block de-
fective
- Motor terminals or ca-
pacitor
disconnected
- excessive working
depth
- Soil too hard
- Blades badly
worn
- 223 -
Remedy
- Check the power cable
and fuse
- Check
- By customer service
workshop
- By customer service
workshop
- Reduce working depth
- Correct working depth
- Replace hoe blades
GB
21.08.15 09:02 21.08.15 09:02