Power Supply - Pattfield Ergo Tools PE-EBH 7530 Mode D'emploi

Power supply

The machine can be connected to any light socket-outlet (with 230
Volt alternating current). However, the socket outlet must have an
earthing contact protected by a 16 A circuit breaker. Additionally, a
residual current device (RCD) circuit-breaker with max. 30 mA must
be used!
Power cable for the device
Please only use power cables that are not damaged. The total length
of the power cable should not exceed 50 meters; going beyond this
distance will reduce the power output of the electric motor. The po-
wer cable must have a cross-section of 3 x 1.5 mm
sheath of such machines is frequently damaged.
Some of the causes for this are:
•
Cracking due to old age of the insulation
•
Kinking caused by improper fastening or guidance of the power
cable
Even though power cables with damaged insulation sheaths pose a
lethal hazard, some people still use them. Do not make this mistake!
Cables, plugs and socket couplers must meet the following require-
ments listed below. Power cables used to connect machines must
have a rubber insulation sheath.
The power cables must, at the very minimum, be of type HO5RN-F
and 3-stranded. The cable type must be printed somewhere on the
power cable. Only purchase power cables that are marked! Plugs
and socket couplers for the power cables must be made from rubber
and splash-proof. There is a limit to how long power cables can be.
Longer power cables require larger conductor cross-sections. Power
cables and connecting lines must be regularly checked for damage.
Ensure that the lines are de-energized before checking them. Com-
pletely unwind the power cable. Also check power cable entry points,
plugs and socket couplers for kinks.
Anl_PE_EBH_7530_SPK7.indb 217 Anl_PE_EBH_7530_SPK7.indb 217
2
- 217 -
. The insulating
21.08.15 09:02 21.08.15 09:02
GB