Pattfield Ergo Tools PE-EBH 7530 Mode D'emploi page 210

Preliminary measures
•
Always wear sturdy, non-slip footwear and long trousers when
working. Never operate the machine barefoot or in sandals.
•
Check the ground on which the machine will be used and remove
all objects that could be caught up and violently flung out by it.
•
Before using the machine, always visually examine the tools for
excessive wear or damage. To prevent any imbalance, replace
worn out or damaged parts and mounting bolts as a set only.
•
The power cables used are not to be of a lighter duty class than
light rubber-insulated H05RN-F in accordance with DIN 57282/
VDE 0282 and they must have a cross section of at least 1.5 mm
The connection must be splash-proof. The power cable must be
fed through the stress-relief clips and be plugged into the switch/
plug block. Before use, check the cable for damage and signs of
aging. Never use the machine with worn or damaged cables. If the
cable is damaged while working, pull the power plug immediately
and only then inspect the damage. Do not touch the power cable
until the plug has been pulled.
•
Socket couplers to connection elements must be made from rub-
ber, soft PVC or other thermal material of equal rigidity or coated
GB
with such material.
•
Make sure that all nuts, bolts and screws are tightened securely
and that the machine is in safe working condition.
•
The equipment may only be connected to a power supply pro-
tected by means of an earth-leakage circuit breaker (RCD) with a
maximum operating current of 30 mA.
Handling
•
Work only in daylight or in good light.
•
Always maintain good footing on inclines.
•
Only operate the machine at a walking pace.
•
Work perpendicular to the slope, never up or down it.
•
Be particularly careful when you change direction on a slope.
•
Do not work on overly steep inclines.
Anl_PE_EBH_7530_SPK7.indb 210 Anl_PE_EBH_7530_SPK7.indb 210
- 210 -
.
2
21.08.15 09:02 21.08.15 09:02