Before Starting The Equipment - Pattfield Ergo Tools PE-EBH 7530 Mode D'emploi

Caution!
Residual risks
Even if you use this electric power tool in accordance with in-
structions, certain residual risks cannot be rules out. The fol-
lowing hazards may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask is used.
2. Damage to hearing if no suitable ear protection is used.
3. Health damage caused by hand-arm vibrations if the equipment is
used over a prolonged period or is not properly guided and main-
tained.

5. Before starting the equipment

Before you connect the equipment to the mains supply make sure
that the data on the rating plate are identical to the mains data.
Warning!
Always pull the power plug before making adjustments to the
equipment.
GB
Assembly (Fig. 4-11)
•
Place the motor unit and the push bars on the ground in order
(Fig. 4).
•
Do not forget to slide the cable strain-relief clamp (Fig. 6/Item 5)
over the bottom push bar.
•
Slide the bottom push bar on to the push bar holder and secure
the two components to each other (Fig. 5).
•
Now secure the top push bar to the bottom push bar (Fig. 6).
•
Install the 2-hand safety switch as shown in Fig. 7-10.
•
Secure the cable using the supplied cable securing clips (Fig.
11/7)
Anl_PE_EBH_7530_SPK7.indb 216 Anl_PE_EBH_7530_SPK7.indb 216
- 216 -
21.08.15 09:02 21.08.15 09:02