Pattfield Ergo Tools PE-EBH 7530 Mode D'emploi page 221

8.3 Replace the hoe blades
For safety reasons, we recommend having the hoe blades replaced
by an authorized professional (see address on warranty certifi cate).
Wear working gloves. Use only genuine spare parts since otherwise
the function and safety of the machine cannot be guaranteed.
8.4 Maintenance
Ensure that all mounting components (i.e. screws, bolts, nuts etc.)
are always tightened so that the machine can be safely operated at
all times.
Store the device in a dry room. All the metal parts should be cleaned
and then oil to ensure that they provide a long life. For best results,
clean the plastic parts of the machine with a brush or rag. Do not use
any solvents to remove dirt.
At the end of the season, perform a general inspection of the machi-
ne and remove any deposits which may have accumulated. At the
start of each season, ensure that you check the condition of the ma-
chine. If repairs are necessary, please contact one of our customer
service centers (see address on warranty certifi cate).
Ensure that all moving parts are kept running smoothly (lubricate if
necessary).
Checking the gear oil (Fig. 15)
The oil drainage screw is fi tted to the right side of the gear box. If ne-
cessary, dismantle the blades.
•
Place the electric hoe on its left side to ensure that no dirt or for-
eign bodies get into the gears.
•
Use a 5 mm Allen key to open the oil drainage screw and let the
oil drain off into a container.
•
Refill the equipment with new and high-grade motor lubricating oil.
•
Screw the oil drainage screw back in place.
Anl_PE_EBH_7530_SPK7.indb 221 Anl_PE_EBH_7530_SPK7.indb 221
- 221 -
GB
21.08.15 09:02 21.08.15 09:02