Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PRODUCT ASSEMBLY
IMPORTANT: When moving your Blender, always lift from the Blender base. Base will become
disengaged from pitcher if carried by Blender pitcher or Blender pitcher handle only.
1
Adjust the length of the Blender power
cord.
NOTE: When properly positioned, the pitcher will rest completely on the Blender base.
If not, repeat step 2. Make sure the pitcher is properly locked onto the Blender base.
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
3
Put the ingredients in the pitcher and firmly
place lid.
6
W11382494A.indb 6
2
Tab
Slot
Align the pitcher tabs with the slots on the
base. Rotate the pitcher, approximately 1/8
turn until it clicks into the place.
WARNING
Electrical Shock Hazard
4
Plug the Blender into a grounded 3-prong
outlet, and press POWER. The Power
indicator light will flash when ready.
8/7/2019 4:26:48 PM
Publicité
Table des Matières
Dépannage
