Finishing; Glass Door Removal; Glass Ember Installation - Napoleon EFL42 Instructions D'installation Et D'opération

10

4.0 FINISHING

EN
POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
4.2

GLASS DOOR REMOVAL

THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
A. Remove the 7 screws, as shown in the illustration below.
B. Tilt the top of the door forward until you can hold the sides of the door. Lift the door up and out of the
bottom retainer.
4.1

GLASS EMBER INSTALLATION

Glass front must be removed and the appliance must be mounted in its fi nal location before the glass embers
are installed.
Glass embers may have sharp edges, wear safety glasses and gloves
when handling.
A. CLEAN GLASS MEDIA: Glass media may have a fi ne oil residue
that needs to be cleaned prior to installation. Clean the glass with
mild dish soap, drain, rinse thoroughly and dry before placing into
the tray.
B. Carefully place glass embers into the bottom tray on the front of the appliance as illustrated. Apply an
even layer from side to side.
W415-1179 / 01.15.13
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
WARNING
!
RECONSTRUCTION.
WARNING
!
75.1