Installing The Weights; Installing The Bagger Supports And Brackets - Toro 78463 Manuel De L'opérateur

3

Installing the Weights

Parts needed for this procedure:
2 Weight
4 Carriage bolt (3/8 x 1 inch)
4 Flange nut (3/8 inch)
Procedure
1. Secure the weight to the caster arm using 2
carriage bolts (3/8 x 1 inch) and 2 flange nuts
(3/8 inch) as shown in
2. Repeat this procedure on the other side.
1. Carriage bolt (3/8 x 1 inch) 3. Flange nut (3/8 inch)
2. Weight
Figure 6.
Figure 6
4
Installing the Bagger
Supports and Brackets
Parts needed for this procedure:
2 Lower support
1 Upper support
1 Left, upper bracket
1 Right, upper bracket
2 Backer plate
4 Carriage bolt (5/16 x 2-1/4 inches)
8 Flange nut (5/16 inch)
4 Plain washer
4 Hex-head bolt (5/16 x 3-1/4 inches)
2 Flange-head bolt (3/8 x 1-1/4 inches)
4 Locknut (3/8 inch)
2 Flange-head bolt (5/16 x 1 inch)
Procedure
1. Loosely secure the upper support to the rear
engine guard using 2 flange-head bolts (5/16 x
1 inch) and 2 flange nuts (5/16 inch) as shown
in Figure
g341474
1. Flange nut (5/16 inch)
2. Upper support
10
7.
Figure 7
3. Flange-head bolt (5/16 x
1 inch)
g341518