Step2: Connect The Speakers - Pioneer ELITE SC-LX501 Manuel De Base

> Before start > Hookup

Step2: Connect the Speakers

3/8˝
(10 mm)
1
1 Speaker cable, 2 Subwoofer cable
> Setup > Playback
2
Speaker B
> Part Names
in case of:
Pages 3 to 4
Connect 123456 for a 5.1-channel system. With a
7.1-Channel System (with Surround Back Speakers), also
connect 7 and 8. Up to two powered subwoofers can be
connected. The same signal is output from each of the
SUBWOOFER jacks. With this connection, you can
connect one more set of front speakers to use as a
Speaker B System. Switch Speakers A/B with "Speakers"
in AV Adjust (P26). Note that sound is not output from
the surround back speaker when A+B is selected.
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. Full Auto
MCACC" (

Make sure the exposed wires of the speakers do not stick out of
the speaker terminals when connecting. If the exposed wires of
the speakers touch the rear panel or the + and – wires touch each
other, the protection circuit will be activated.
P20) in Initial Setup.
En
9