Pioneer ELITE SC-LX501 Manuel De Base page 11

> Before start > Hookup
3/8˝
(10 mm)
1
1 Speaker cable, 2 Subwoofer cable
> Setup > Playback
For high-
frequency
For low-
frequency
> Part Names
2
Connect front speakers compatible with Bi-Amping
connection to the FRONT jacks and the SURROUND
BACK jacks. Make sure you remove the jumper bar fitted
between the woofer jacks and tweeter jacks of the front
speakers. In case of Bi-Amping connection, refer to the
instruction manual of your speakers. Up to two powered
subwoofers can be connected. The same signal is output
from each of the SUBWOOFER jacks.
Make sure the exposed wires of the speakers do not stick out of
the speaker terminals when connecting. If the exposed wires of
the speakers touch the rear panel or the + and – wires touch each
other, the protection circuit will be activated.
in case of:
Page 8
Setup
0 Bi-Amping connection requires you to change
some settings. Select "Yes" in "Bi-Amp" in "1. Full
Auto MCACC" ( P20) in the Initial Setup.

En
11