Invacare Stand up support Manuel D'utilisation page 3

Installation:
The stand up support is mounted as the lifting pole.
1. Remove the plastic cap from the bed lifting tube.
2. Mount the stand up support in the lifting pole tube (fig. B)
- oriented as shown on fig. D
3. Elevate the bed to top position for better to access to
the underside.
4. The disc must be mounted at the bottom of the stand up
support pole with 2 screws. (C)
5. Tighten the screws with the enclosed Allen-Key.
NOTE! Make sure that both screws are tightened.
• Correct mounted (fig. D) - The stand up support must
be mounted along the bed with the handle pointed away
from the bed.
• Incorrect mounted (fig. E and F) - The stand up support
must not be mounted so the handle pointed in or turned
away from the side of the bed.
Application:
The stand up support can be used on the following bed types:
SB400, SB750, SB755, Alegio and Etude
D
E
B
C
F