Fronius PullMig Instructions De Service page 18

Danger from electric current.
This can result in serious injury and damage to property.
► All cables, lines and hosepacks must be properly connected, undamaged, correctly in-
Risk of burns from hot welding torch components and hot coolant.
This can result in severe scalds.
► Before commencing any of the work described in these Operating Instructions, allow
Risk of damage due to operation without coolant.
This can result in serious damage to property.
► Never operate a water-cooled welding torch without coolant.
► Fronius shall not be liable for any damage resulting from such action. In addition, no
Risk of injury due to rotating parts
This can result in serious injury
► Only operate PullMig with lid closed.
System require- Power source
ments -
-
Software
-
-
Options
-
-
18
WARNING!
sulated and adequately dimensioned at all times.
CAUTION!
all welding torch components and the coolant to cool to room temperature (+25 °C, +77
°F).
CAUTION!
warranty claims will be entertained.
CAUTION!
TS 4000 / 5000
TPS 2700 / 4000 / 5000
Power source: Software version 3.10.22 or higher
Wire feed: Software version 1.70.16 or higher
Installation set „PMR4000 PullMig TS/TPS 2700-5000 (4,100,217)"
Software „FS Drive (4,061,113)"