Technical Data; Ce Mark / Ce Declaration Of Conformity - Kerbl CowCleaner Duo 18810 Mode D'emploi

3. Content of the warranty
Our warranty represents an independent extension of the legal warranty against defects.
We also cover any defects which, following the transfer of risk, occur within the warranty period and which are notified
to us within this period.
4. Scope of services in the event of a warranty claim
The warranty comprises exclusively the material costs of spare parts for the parts that require replacement or are faulty.
Excluded from the warranty are in particular labour or wage costs for the replacement / repair of defective parts,
materials and services in relation to regular maintenance, as well as transport costs arising in relation to any repair.
In particular, no costs will be covered if repairs are undertaken without first contacting the manufacturer.
5. Restrictions
Essentially excluded from the warranty are defects that are caused by negligent or wilful damage to the product,
incorrect use, incorrect operation and/or unprofessional electrical connections or excessive strain on the product.
This warranty does not cover wear parts in the product, such as brushes, seals, bearings, guides, rollers, rubber buffers,
springs, etc.)
6. Voiding of the warranty
The warranty shall become void independently of the warranty period set out above should the user not carry out the
prescribed maintenance in a timely and correct manner or have such work carried out, or fail to replace worn parts in
good time or continue to use the product despite recognisable defects and/or damage in an un-repaired state. The
warranty shall also become void should the product be opened, repaired and/or its technology modified by any
unauthorised and/or inappropriate specialist.
7. Warranty disclaimer
Liability for compensation is restricted to cases of gross negligence and/or wilful intent. This limitation of liability does
not apply to injury to life, limb or human wellbeing.
8. General warranty
The statutory rights of the consumer are not affected by this warranty.

10. Technical data

Article number / type designation:
Voltage:
Output:
Speed:
Safety class:
Protection class:
Dimensions:
Fastening drill hole distance:
Weight:
Brush diameter:
Brush length:
11. CE mark / EC declaration of conformity
18810
230 V / 50 Hz
0.37 kW
60 rpm
IP 56
I
H 115 x W 40 x D 105 cm
350 x 872 mm (W x H), diam. 17 mm (see Figure 3)
approx. 150 kg
315 mm / 420 mm
650 mm / 550 mm
42