Maintenance And Repair; Technical Data - Kerbl FastHeat Mode D'emploi

Chauffe-lait pour veaux avec convecteur de chauffage

Table des Matières

Les langues disponibles

4.3. Set the desired temperature on the thermostat. ( 0 ) denotes „off", (

(

) denotes a temperature of approximately 80°C. The red control lamp is on during the heating phase.

4.4. Attention: only operate the device under supervision.

4.5. During longer warming periods please ensure that the liquid covers the heating ring at all times and the liquid level does not

sink. Never cover the device or the container.

4.6. When the red control lamp goes out this means the desired temperature has been reached. Turn the thermostat to "off" and

remove the plug from the socket. Leave the calf milk warmer in the liquid for a further minute before removing it.

4.7. The heating element will still be hot after the plug is removed and must not be touched. Lay the calf milk warmer on a non-

ﬂ ammable surface. Storage on a ﬂ ammable surface (straw) is prohibited!

4.8. The calf milk warmer must be cleaned after every use. The heating element can be cleaned using a brush and a lukewarm soap

solution. Please use a soft cloth to clean the handle section. It must never come into contact with solvents (acetone, petrol, alcohol

or similar).

5. Maintenance and Repair

The device is maintenance free. The device must be taken out of operation immediately in the event of a defect. If repair is neces-

sary please contact a specialist electrician or send the device to the manufacturer for repair. A defective connection line may also

only be repaired by the manufacturer or by a specialist electrician in order to avoid hazard.

Power:

1700 W

Voltage:

230 V

Protection class:

IPX 7

Weight:

2.8 kg

) denotes a temperature of approximately 40°C and

= approx. 40 °C

Table des Matières

14150