Ribimex Ribiland 511706 Manuel D'instructions Et D'utilisation page 15

placed directly on the ground or on the bottom of the well, pond or vessel.
For example, use a brick to support the pump.
Warning: to dry out premises (cellar draining for example) it will be necessary to place the pump
below floor level.
4. During installation, NEVER hang the pump by the power cable or discharge hose.
Hang up the pump using the transport handle (6) or the eyelet (5).
5. Pump installation must be carried out according to national / local regulations. Should you have
any doubt, seek assistance from a qualified person.
6. Follow the max submersible depth (H1) and the conveying height (H2) specified in table 1.
4.5- Clear water – dirty water mode
4.5.1- To switch from Clean Water Mode to Dirty Water Mode (Fig.6+7+8)
Place the pump vertically on a flat ground.
With your feet, step on the two flat supports (15) (Fig.6).
Hold the handle (6) with your hand and lift up the pump until it can't move.
Rotate the locating ring (9) towards the "23mm" direction until it can't move (Fig.7).
In dirty water mode, the pump suction capacity is up to 23mm from the ground and with particles in
suspension that are less than 20mm in diameter (Fig.8).
4.5.2 – To switch from Dirty Water Mode to Clean Water Mode (Fig.6+7+9)
Flush the mud and sand on the pump before switching.
Place the pump vertically on a flat ground.
With your feet, step on the two flat supports (15) (Fig.6).
Hold the handle (6) with your hand and lift up the pump until it can't move.
Rotate the locating ring (9) towards the "1mm" direction until it can't move (Fig.7).
In clear water mode, the pump suction capacity is up to 1mm from the ground and with particles in
suspension that are less than 5mm in diameter (Fig.9).
4.6- Finish Running
4.6.1- When drawing water under low water intake,
When all the water has been pumped out, at this time, unplug the plug form the power source.
Then lift the pump up to a water container.
Unscrew the output connector (2) for discharge port (1) and drain all the water in the discharge hose
into the container.
4.6.2- When under other working conditions (except complete water draining)
Unplug the plug directly from the power socket.