KTM 63506915144 Mode D'emploi page 30

5 ASSEMBLY
12
–
Position air filter support
–
Mount and tighten original screws
Guideline
Screw, air filter box
502212-01
–
Mount oiled air filter
Oil for foam air filter (
The top and bottom of the air filter are seated between the
plastic clamps of the air filter support.
502213-01
–
First hook fastening clamp
clamps at the bottom, and then fold upward and hook it into
the plastic clamp at the top.
The TOP marking on the fastening clamp is located on the
outside.
Tip
For easier assembly, the inside of the holding lugs of
the fastening clamp can be slightly rounded off with a
file.
502214-01
–
Optionally, the sand cover
ter can be fitted. To do this, remove the fastening clamp
again, position the sand cover for the air filter, and mount it
using the fastening clamp.
Info
To remove the sand cover for the air filter, simply pull it
off.
502215-01
Final steps
–
Install the side cover on the left (see Owner's Manual).
–
Install the right side cover (see Owner's Manual).
5
.
bm
.
M5 3 Nm (2.2 lbf ft)
2
(included).
p. 15)
1
(included) into the plastic
bt
(not included) for the air fil-
1