Temperature Control; Power Control; Eco Mode - Inverter 3026 CE Mode D'emploi

6)

Temperature control

When the heater is ignited, you can set the required temperature. Press TEMP
ADJ button and set desired temperature.
* The Room thermo-sensor controls the heat automatically, according to the
temperature selected.
* As the room thermo-sensor senses the temperature around the unit, there may
be a slight difference in temperature between the room thermo-sensor and any
thermometer in the room.
* The Room thermo-sensor does not work properly if the unit is exposed to
direct sunlight or a draught, or exposed to heat from other heating / lighting
appliances or during the first 3 minutes after each switch on.

Power control

Depending on
automatically run at a lower or a higher output power between 800w and 3200 w,
so as to let the room obtain the set temperature after a certain period of time.
7)

ECO mode

Press ECO button.
ECO lamp turns on.
To cancel, press ECO button again.
Note : ECO mode does not work during the first 3 minutes after each switch ON.
What is the ECO operation ?
If the temperature gets three degrees C higher than the selected temperature, the
unit automatically shuts down when the temperature falls to the temperature se-
lected, the unit automatically ignites again to maintain the temperature.
Set ECO mode on warm days or in a comparatively warm room.
Notes : * ECO lamp remains on when ECO shuts the unit off.
* Once ECO mode is set it is stored automatically until/unless a power
failure occurs or the power plug is removed.
the room temperature and the set temperature, the unit will
52