Selection Of Location - Inverter 3026 CE Mode D'emploi

2. SELECTION OF LOCATION

Choose the location for your heater carefully, to get optimum performance from the Unit.
SAFETY PRECAUTIONS TO BE TAKEN
* ENSURE ADEQUATE VENTILATION. For example, in
a modern home , insulated to current standards:
-Use ONLY in a room with an openable window or
external door,
- Plus a permanent vent of minimum size 155cm2
- With a minimum room size of 46m3 (3016), 49m3 (5016),
61m3 (6016).
- Keep all obstructions and inflammable materials away
from the Unit, and observe the minimum distances shown
on the following illustration.
- Keep curtains away from the Unit. Likewise, the Unit
should be placed away from the wall. Failure to do so may
cause overheating, triggering the safety device and
automatically switching off the heater.
* Place the heater on a flat surface, on the floor.
* Do not place on or below an unstable shelf.
* Do not use where flammable gases may be generated or
may have accumulated.
Use in properly ventilated areas only
*
KEEP UNIT AWAY FROM LOCATIONS WHICH ARE:
* In a room with lots of people passing through, or exposed to draughts;
* Confined areas such as under a mantlepiece;
* In direct sunlight, or very dusty areas, or where the temperature tends to rise quickly.
* Locations more than 1,000 metres above sea level.
* In places where gas or chemicals are used, such as beauty salons, barber's shops,
chemical plants, laundries,etc..
* A good choice is a location, near or under a window,
where the heater is directly in contact with fresh air .
* Air circulation in front of the heater must not be
restricted by any obstacle.
In such circumstances, the room temperature could be
unstable and the Unit could overheat
Try to leave maximum free space in front of the heater.
.
OPTIMUM EFFICIENCY
42
COLD AIR
WINDOWS
WARM AIR
WARM AIR
100 CM