Before Using The Unit; Setting The Unit; Fuel To Be Used - Inverter 3026 CE Mode D'emploi

6. BEFORE USING THE UNIT

1) Setting up the unit
Remove the heater unit from the carton box and remove packing materials.
Remove fuel tank from the unit.

2) Fuel to be used

Use only uncontaminated C1 Paraffin BS 2869C1 or Tozane
Reduced Odour Liquid Fuel, as recommended by the
Distributor.
More than 95 % of problems are due to using a wrong type of fuel. These problems
are not covered by our Guarantee.
To achieve optimum performance, it is recommended that only Tozane (Reduced
Odour), with the aromatics removed and totally free of impurities (max
1 % of aromatics and a flash-point above 61°),or pre-packaged C1 paraffin to BS2869
is used.
Never use contaminated fuels, or fuels which have been chemically treated, or
contain water or petrol.
Never use kerosene, petrol or diesel
WARNINGS:
 Use ONLY recommended fuels (above).
Ensure that fuels NEVER become mixed with water.

 NEVER use containers which have been used for petrol or methylated
spirits or other fuels.
FUEL STORAGE
Store your fuel out of the sun and away from other heat sources.
Fuel which has been stored too long loses its purity, and thus its efficiency.
FILLING WITH FUEL.
Even when the removable tank is out of the heater it will run for a time.
You should fill your heater:
 When your heater is switched off.
 And in a place away from the heater.
You must always check that the tank cap is properly fastened. Please re-fill away from
any other heat source or fire.
46