Side Opening - Swing-N-Slide NE 5010 ProJect 512 Manuel D'instructions

sIDe oPenInG

oPtIon 1
Fig. 36
• BOTTOM OF LADDER RAIL •
2-1/2'' screw
1-1/4'' screws
Fig. 37
2-1/2'' screws
(2)
2-1/2'' screws
each side
EX AMPLE OF LA D D ER RU N G IN STA L LAT I O N
(6)
1-1/4''
screws
(3)
8''
O. Ladder ssembly.
1. On ladder rails, mark all measurement locations for
each side with a pencil. Draw an angle line
connecting measurements for each ladder rung
alignment. (Fig. 35)
2. Align top of step bracket with line and screw in
place. Install a ladder rung at each of the four
locations. (Fig. 35) and (Fig. 36) Repeat on other
ladder rail.
3. Attach 2'' x 4'' x 23-1/4'' to siderails using
(2) 2-1/2'' screws per side.
4. Secure ladder to unit. (Fig. 37) and (Fig. 38)
Note: The top step should be 11" below the deck
and all steps should be level.
5. Screw (2) 2-1/2" screws into the ends of each ladder
rung through the left and right side rails. (Fig. 38)
(3)
2-1/2'' screws
each side
41
ProJect 512
Fig. 38
(2)
2-1/2'' screws
each joint