Swing-N-Slide NE 5010 ProJect 512 Manuel D'instructions page 202

Project 515
Fig. 22
T-nut
Washer
2-1/2'' screws
5-1/2'' Hex Bolt
2-1/2'' screw
S. -Frame ssembly cont.
1. 1. Tap T-nut into 3/8'' hole as shown in (Fig. 22)
Note: If using Laminated Swing Beam, make sure T-nut teeth do not fall between seams of 2'' x 6''s.
2. ttach -Frame beam to Swing Beam using (2) 5-1/2'' hex bolts and 4 screws.
3. Tighten hex bolt to flush with top of T-nut. Repeat on other bracket.
34