Swing-N-Slide NE 5010 ProJect 512 Manuel D'instructions page 33

2-1/2'' screw
T. -Frame ssembly cont.
1. Tap T--nut into 3/8'' hole as shown in (Fig. 27)
Note: If using Laminated Swing Beam, make sure T-nut teeth do not fall between seams of 2'' x 6''s.
2. Attach A-Frame beam to Swing Beam using (2) 5-1/2'' hex bolts and 4 screws.
3. Tighten hex bolt to flush with top of t-nut. Repeat on other bracket.
T-nut
Washer
2-1/2'' screws
5-1/2'' Hex Bolt
33
ProJect 512
Fig. 27