Portable Winch PCA-1806 Instructions D'assemblage page 2

PCA-1806
Pylon Mount Anchor
System
ASSEMBLY INSTRUCTIONS
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Here is your PCA-1806 assembled:
The box of the PCA-1806 contains:

Pylon Mount Body

Four (4) threaded rods assembled*
*Each rod must have one nut, one hook, one flat washer and one star
knob.
Remove the nut on the threaded rods (4x);
Screw each rod in the threaded holes of the Pylon Mount Body (4x);
Install the nuts on the threaded rods on the inside of the Pylon
Mount Body (4x);
Tighten the nuts by hand. Be sure to have at least three (3) threads
showing on the end of each rod (4x);