Power Fist 8955114 Manuel D'instructions page 14

8955114
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Motor overheats.
Motor does not turn
on.
Motor runs, but steel
cable drum does not
turn.
Motor runs slowly or
without normal
power.
Motor runs in one
direction only.
Motor is water
damaged.
14
12V DC Winch
Possible Cause(s)
Winch running time
too long.
1. Control Box
malfunctioning.
2. Remote damaged.
3. Defective motor.
4. Internal damage or
wear.
5. Remote not
properly plugged in.
6. Battery cables
damaged or not
properly connected.
The clutch is not
engaged.
Insufficient current or
voltage.
1. Defective or stuck
Control Box.
2. Remote damaged.
Submerged in water or
water from pressure
washing.
Suggested Solution(s)
Allow winch to cool down
periodically.
1. Tap Control Box to loosen
contacts.
2. Replace remote.
3. Check for voltage at armature
port with switch pressed. If
voltage is present, replace
motor.
4. Have technician service
winch.
5. Check the remote plug is
firmly seated.
6. Replace damaged cables or
reconnect clips to the battery.
Move the clutch handle to the
engaged position. If problem
persists, a qualified technician
needs to check and repair.
Connect to appropriate power
supply.
1. a. Tap Control Box to loosen
contacts.
1. b Repair or replace Control
Box.
2. Replace remote.
Allow to drain and dry
thoroughly. Have a service
technician repair and lubricate
the winch.
For technical questions call 1-800-665-8685
V1.0