Electronic Ignition; Cooling System - GAS GAS enducross EC 2008 Manuel D'entretien

ELECTRONIC IGNITION

This motorcycle uses a capacitor discharge ignition system (CDI).
The ignition system should never require adjustment unless the
stator of the magnetic flywheel was incorrectly installed during engine
reassembly.
If necessary, inspect and adjust as follows:
Adjustment
- Remove the magnetic flywheel cover (A).
- Make sure that the mark on the stator plate is aligned with the
mark on the crankcase.
(A)
- If the marks are not aligned, loosen the magnetic inertia wheel
screws and turn it.
- Tighten the screws securely.
- Install the magnetic flywheel cover.
Engine tune-up can be adjusted to match the rider´s preferences
and skills.
- Remove the magnetic flywheel cover.
- Loosen the stator screws.
- Adjust the engine tune-up by changing the position of the stator
within prudent limits
For the best engine performance, it is very important to adjust
the engine tune-up within the set of limits described.
125 cc
- Tighten the stator screws.
- Install the magnetic flywheel cover.
- Test ride the motorcycle and readjust the engine tune-up, if
necessary.

COOLING SYSTEM

200 / 250 / 300 cc
Radiator Hoses
Check the radiator hoses for cuts or deterioration, and the connections
for looseness and leaks.
Radiator
Check the radiator fins for obstructions (insects or mud). Remove
any obstructions with a stream of low water pressure.
19
- -
NOTE
NOTE