Brakes - GAS GAS enducross EC 2008 Manuel D'entretien

Tighten the bolts, front first and then the rear, to 25 Nm of torque.

BRAKES

Disc and disc pad wear is automatically compensated for and has
no effect on the brake lever or pedal action. So there are no parts
that require adjustment on the brakes except brake lever free play
and brake pedal position
Front brake lever free play
Adjust the front brake lever (A) to match your requirements. To
adjust, loosen the nut (B). After adjustment, tighten it securely. Then
check that the brake response is correct.
Rear brake pedal position
When the brake pedal is in rest position, there should be a free play
of 10 mm.
Check the brake for good braking power and no brake drag.
If the handlebar is
installed correctly,
there will be an
even gap at the
front and rear after
tightening (A).
(A)
(B)
If the brake pedal feels spongy when it is applied, there might be air
trapped in the brake pump or the brake may be defective. Since it
is dangerous to operate the motorcycle under such conditions, have
the brake checked inmediately.
30
- -
(B)
(A)
(A). Brake pedal.
(B). 10 mm free play.
WARNING