Parkside PSHL 2 D1 Consignes D'utilisation Et De Sécurité / Traduction Du Mode D'emploi D'origine page 30

Using the device
low as possible on the head and as close
as possible to your face.
Before carrying out welding work, set
„
the appropriate darkening level. The
darkening level can be set manually
between 5 and 9 and between 9
Table to adjust the darkening levels
1.5 6 10
Grind
SMAW
MAG
TIG/
8
GTAW
MIG
(heavy)
MIG
(light)
PAC
PAW 4 5
SMAW: Welding with coated
electrodes
MIG (heavy): MIG welding of heavy metals
MIG (light): MIG welding of light metals
and alloys
TIG/GTAW: Inert gas welding
ATTENTION! The darkening control
has the "Grind" adjustment position. If the
darkening control
9
then auto-darkening is deactivated. Only use
the setting if you do not want to use welding
helmet for welding. Auto-darkening is then
not active.
Prior to each use check the light seal.
„
30 GB/IE
15 30 40 60 70 100 125 150 175 200 225 250 300 350 400 450 500
Grinding function – auto-darkening is not active
8 9
8 9
9
9
10
9
6 7 8
is set to this position,
and 13, by turning the darkening control
on the outside of the helmet.
9
Using the darkening switch
can set whether the darkening will be
set between levels 5-9 or 9-13 on the
darkening control
Arc current (Amps)
10 11
10 11
10 11
10 11
11
10 11 12
9 10 11
MAG: Welding with metal active gas
PAC: Plasma cutting
PAW: Plasma welding
Grind: Grinding function: Auto-darkening
is not active. Only use the setting if
you do not use welding helmet for
welding.
Perform test procedure
9
You can use the test button
„
whether the welding helmet's darkening
feature is working properly.
Go towards an external light source at
„
more than 40 W with the viewing pane
and check whether the pane becomes
darker or lighter. To do so, turn the
darkening control
"Grind" to the next position. This sets the
filter to auto-darkening mode.
you
20
.
9
12 13
12
12 13
12 13
12 13 14
13
12
to check
11
clockwise from
9
600
14
13 14
14