Parkside PSHL 2 D1 Consignes D'utilisation Et De Sécurité / Traduction Du Mode D'emploi D'origine page 26

Safety instructions
Prior to each use, check that
„
it is working properly by
pressing the "Test" button.
The product is not suitable for
„
laser welding.
The product is only approved
„
for use within a temperature
range of between -5 °C to
+55 °C.
The product is not fire-resistant.
„
Welding helmet and UV filter
„
must not be exposed to any
heat or moisture.
Do not remove the ADF filter
„
from the welding helmet and
never open the housing of the
ADF filter without authorisation
from the manufacturer.
Prior to each use, check
„
whether the Welding/Grinding
setting was selected correctly.
The viewing pane must be
„
installed on the outer side of
the ADF filter. Otherwise, the
ADF filter can get damaged.
Do not carry out any modifi-
„
cations/replacements on the
welding helmet and ADF filter
without consent.
If the filter does not darken
„
automatically whilst welding
please stop the operation
immediately and contact the
dealers without delay.
Do not use any alcohol, fuel
„
or diluting agents to clean the
26 GB/IE
ADF filter. Do not place the
ADF filter in water.
The response time of the ADF
„
liquid crystal slows down if the
ambient temperature is lower,
however this does not have
an impact on the protective
functions.
Please replace the housing
„
of the ADF filter immediately
if it is damaged or scratched
because this can impair
visibility and the protective
performance.
Please replace the viewing
„
pane immediately if it is bro-
ken or scratched. Do not use
any hard objects to replace the
viewing pane of the filter.
Regularly clean the surfaces
„
of the ADF filter, sensor and
solar cells.
The welding helmet cannot
„
withstand any damages that
are caused by a heavy blow,
explosion or abrasive liquids.
The useful life depends on
„
many different individual
factors such as usage, clean-
ing, storage and maintenance.
Regular inspections and
replacement in the case of
damage are recommended.
The material used to manufac-
„
ture the product will age
over time. This can result in