Installing The Wall Control - Kichler 300032 Manuel D'instructions

INSTALLING THE WALL CONTROL

All wiring must be in accordance with the National Electrical Code and local electrical
codes. Electrical installation should be performed by a qualified licensed electrician.
NOTE: SWITCH INSTALLATION MUST COMPLY WITH ALL LOCAL AND NATIONAL
ELECTRIC CODE.
WARNING: Shut off main power at the circuit breaker or fuse panel before
continuing.
Step 1. Remove the existing wall plate and the old switch from the wall outlet box.
Disconnect wires. (Fig. 15)
Step 2. Place the wall control to the outlet box, connect the wires with wire
connectors provided. (Fig. 16)
*Connect the lead wire (HOT) from the outlet box to BLACK wire marked
"AC IN L" from wall control.
*Connect the lead wire (LOAD) from the outlet box to BLACK wire marked
"TO MOTOR L" from wall control.
*Connect the GROUND from the outlet box to GROUND from wall control.
Step 3. Secure the wires connectors and make sure there are no loose strands or
connections. Carefully tuck wire connections back inside outlet box and secure the
wall control to outlet box with screws provided. Snug the face plate to wall control.
Outlet Box
Switch
Fig. 15
Wall Control
Outlet Box
HOT
TO 120V SOURCE
TO LOAD
GROUND WIRE
FROM CEILING
Fig. 16
48" Volos LED | 13
Wall Plate
Face Plate