Hanging The Motor Assembly - Kichler 300032 Manuel D'instructions

HANGING THE MOTOR ASSEMBLY

REMEMBER to turn off the power before you begin installation.
This is necessary for your safety and also the proper programming
of the control system.
To properly install your ceiling fan, follow the steps below.
Step 1. Before attaching fan to outlet box (not included), ensure the
outlet box is securely fastened to at least two points to a structural
ceiling member (a loose box will cause the fan to wobble). Pass the
120 volt supply wires from the outlet box through the center of the
mounting plate. Install mounting plate to outlet box in ceiling using
the screws and washers included with the outlet box. (Fig. 4)
Step 2. Hook the motor assembly onto the mounting plate as
shown. You can now proceed with the electrical wiring of your fan.
(Fig.5)
6 | KICHLER.COM
Outlet Box
Screw
Fig. 4
Fig.5
Mounting Plate
Washer
Mounting Plate
Motor
Assembly